How To Use MB18 Ultra 5 Marble Polishing Powder – 1lb (0.45kgs):

• Prepare the surface to be polished by honing it to the highest clarity possible.
• Protect surfaces that could be damaged by splatters with proper masking material.

FLOORS:

• Target an area of approximately 10 – 15 sq. ft.
• In the middle of the target area, sprinkle approximately 1 ½ - 2 oz. (3 – 4 tablespoons) of MB18 Ultra 5 Marble Polishing Powder – 1lb (0.45kgs) powder in a circular pattern slightly smaller than the diameter of the floor machine.
• Using a hog’s hair pad (highly recommended), position the floor machine with a full tank of water on top of the powder.
• For best results, use 1.5 HP minimum and do not exceed 175 RPM.
• Release some water and swiftly swing the machine back and forth over the targeted area to evenly spread the slurry. (Note: keep the slurry thick; not too wet)
• Polish slowly with a spiral motion moving from one end of the targeted area to the other and back.
• Continue polishing for 2.5 – 4 minutes.
• Then check the surface with a squeegee.
• You should have a high polish at this point.
• Next release just enough freshwater onto your target area to make vacuuming the used slurry easy and vacuum to remove.
• Then clean with a neutral cleaner such as MB1 Floor Amore – 946ml or MB15 Stone Glow.
• Now repeat this process in the next section.

COUNTERTOPS

• Target an area of approximately 3 – 4 sq. ft.
• On the targeted surface, sprinkle 1/2 teaspoon of the MB18 Ultra 5 Marble Polishing Powder – 1lb (0.45kgs) on the surface to be polished in a circular pattern slightly smaller than the polishing pad you are using.
• Spray some water on the powder and over the rest of the targeted area.
• Set the speed of the right-angle grinder/polisher (variable speed is a MUST) to the slowest speed.
• Using a hog’s hair pad, move the machine over the targeted area slowly, applying steady pressure.
• Check the surface for results after approximately 2 - 3 minutes.
• If you have a high polish, semi-flush the section and pull the slurry down to the next section, and repeat.

COVERAGE: Depending on the type of stone, expect coverage of MB18 Ultra 5 Marble Polishing Powder – 1lb (0.45kgs) is approximately 125 – 200 sq. ft. per pound.

Safety

• Refer to the Safety Data Sheet (SDS) before use of MB18 Ultra 5 Marble Polishing Powder – 1lb (0.45kgs)

Additional Information on MB18 Ultra 5 Marble Polishing Powder – 1lb (0.45kgs):