How To Use MB12 Caliber Marble Polishing Powder – 1lb (0.45kgs):

• Prepare your surface for polishing by completing the honing process, to the highest clarity possible for the best results.
• Mask/Protect surfaces that could potentially be damaged by splatters with proper masking material.

COUNTERTOPS:

• Target an area of approximately 2 - 3 sq. ft.
• Sprinkle ¼ teaspoon of MB12 Caliber Marble Polishing Powder – 1lb (0.45kgs) on the surface to be polished in a circular pattern, slightly smaller than the polishing pad to be used.
• Using a spray bottle, add enough water to the powder to soak the powder.
• Use a white polishing pad with a right-angle grinder/polisher (variable speed is a MUST).
• Set the speed to low.
• Place pad on top of the powder mixture.
• While controlling the speed with the trigger and applying as much pressure as the machine can take, start spreading the slurry over the targeted area, keeping a very low RPM, until it’s almost dry.
• Pull the trigger all the way while gradually lightening the pressure and buff to a shine while moving the machine swiftly over the targeted area.
• Remove any streaking with a clean dry white pad and a mist of water.

FLOORS:

• Target an area of approximately 10 – 12 sq. ft. and sprinkle 1 tablespoon of MB12 Caliber Marble Polishing Powder – 1lb (0.45kgs) in the center of the area in a circular pattern slightly smaller than the diameter of the floor machine.
• Using a spray bottle, add enough water to the powder to soak the powder.
• Using a hog’s hair pad and a floor machine with at least 1.5 hp and not exceeding 175 RPM, swiftly swing the machine side to side over the target area to evenly spread the product slurry.
• Then polish slowly with a spiral motion, moving from one end of the targeted area to the other and back until the slurry is dry and the stone surface becomes shiny.
• The first area will probably need to be done a couple of times for proper pad build-up.
• We suggest not exceedingly approx. 100 sq. ft. with one side of the pad.
• After that, flip the pad over and go another 100 sq. ft. or so (hogs hair pads can be hosed off a couple of times and reused, before disposal.)
• Remove any streaking with a clean dry hog’s hair pad and a mist of water.

NOTICE: The directions above are average. Different stones may require more or less powder and/or water; a faster or slower pace, according to their inner physical and chemical characteristics. MB12 Caliber Marble Polishing Powder – 1lb (0.45kgs) can be considered as universal as they come, but it’s no substitute for professionalism.

COVERAGE: Depending on the type of stone, expect coverage of approximately 500 to 1,000 sq. ft. per pound.

Safety

• Refer to the Safety Data Sheet (SDS) before use of MB12 Caliber Marble Polishing Powder – 1lb (0.45kgs)

Additional Information on MB12 Caliber Marble Polishing Powder – 1lb (0.45kgs)