Chemron Protecta 1L
Chemron Protecta 1L
Long-Lasting Anti-Corrosion Coating for Heavy-Duty Protection
Chemron Protecta is a high-performance anti-corrosion coating that forms a thin, semi-permanent wax-like film to protect metal and painted surfaces from weathering, oxidation, and corrosive environments. Ideal for use across mining, agriculture, construction, and industrial sectors, it provides invisible yet powerful protection without leaving a sticky or oily residue.
Powerful Corrosion Control for:
- Mining equipment
- Agricultural machinery
- Earthmoving and construction gear
- Workshop tools, cables, and jigs
- Industrial machines during transport or off-season storage
Key Features:
- ✅ Invisible, Wax-Like Barrier – Leaves a clear, non-tacky film that resists dust and grime.
- ✅ Highly Weather-Resistant – Ideal for both open-air and covered storage conditions.
- ✅ Non-Oily, Clean Finish – No greasy residue means less dust accumulation and easier handling.
- ✅ Wicks into Crevices – Seeps into hard-to-reach areas prone to rust.
- ✅ Easy to Remove – Use a solvent like Chemron Dislodge for complete removal when needed.
How effective is this anti-corrosion coating?
In the test sample photos below you can see how this anti-corrosion coating provides protection to raw steel.
- Before – An I-Beam was ground at both ends to present a clean fresh surface of raw steel.
- After – One coat of Protecta was sprayed onto the righthand area and the sample was left outside to weather.
A close-up photo of the water beading on the protected area
When to Use Protecta:
✔️ Pre-use Protection – Apply to new machinery to preserve finishes and simplify future cleaning.
✔️ Between Wash Cycles – Protect active equipment from grime and exposure between maintenance.
✔️ Short & Medium-Term Storage – Prevent rust and corrosion during idle periods or transportation.
Application Instructions:
- Ready-to-use formula — no dilution required.
- Apply by spray, dip, or brush, ensuring full surface coverage.
- Allow to drip dry on racks or air dry for 24 hours before use.
- Do not apply in high humidity or wet conditions.
- For cleaning/removal, use a solvent degreaser such as Chemron Dislodge.
Important: Not recommended for use on natural stone surfaces.
Whether you're preserving new equipment or preparing tools for seasonal downtime, Chemron Protecta offers the invisible shield you can trust against rust, oxidation, and harsh environmental conditions.
